7
1. Remove the top hinge cover.
2. Loosen the top hinge screws using a phillips
head screwdriver.
3. Adjust the door or put a spacer in between and
then tighten the screws.
4. Replace the top
hinge cover.
Door Alignment
(see fig. # 1)
fig. # 1
Electrical Requirement
• Make sure there is a suitable power outlet (115 volts, 15 amps outlet)
with proper grounding to power the refrigerator.
• Avoid the use of three plug adapters or cutting off the third grounding in
order to accommodate a two plug outlet. This is a dangerous practice
since it provides no effective grounding for the refrigerator and may
result in shock hazard.
• Avoid the use of an extension cord because of potential safety hazards
under certain conditions. If it is necessary to use an extension cord, use
only a 3-wire extension cord that has a 3-prong grounding plug and a
3 slot outlet that will accept the plug. The marked rating of the extension
cord must be equal to or greater that the electrical rating of the
appliance.
• Do not install your refrigerator in any location not properly insulated or
heated e.g. garage etc. Your refrigerator was not designed to operate in
temperature settings below 55˚ Fahrenheit.
• Select a suitable location for the refrigerator on a hard even
surface away from direct sunlight or heat source e.g. radiators,
baseboard heaters, cooking appliances etc.
Install Limitations
Use of Extension Cords
7
English
To Next Page
Loading...
