8
pulse irregularity was detected during the measurement. Please
refer to item 2.4. of this manual and consult your doctor with the
related information.
f) The measurement readings remain on the display until you
switch off the instrument. If no button is pressed for a period of
5 minutes the instrument switches itself off in order to preserve
the batteries.
5.5. Discontinuing a measurement
If it is necessary to interrupt a blood pressure measurement for any
reason (e.g. the patient feels unwell), the START button can be
pressed at any time.
The device immediately lowers the cuff pressure automatically.
5.6. Memory - recall of measurements
This blood-pressure monitor automatically stores the last
99 measurement values. By pressing the «M» button, the
last Measurement, as well as previous measurements can
be displayed one after the other.
(MR30: Value of the last measurement) (MR29: Value of the measurement before MR 30)
5.7. Memory– cancellation of all measurements
Attention! Before you delete all readings stored in the
memory, make sure you will not need refer to the readings
at a later date. Keeping a written record is prudent and
may provide additional information for your doctor’s visit.
In order to delete all stored readings, depress the «M»
button for at least 7 seconds, the display will show the
symbol «CL» and 3 short beep sounds will be heard to
indicate deletion of stored readings.
6. ERROR MESSAGES/MALFUNCTIONS
If an error occurs during a measurement, the measurement is
discontinued and a corresponding error code is displayed.
(Example Error no. 1)
To Next Page
Loading...
Need help?
General
