Microlife CARDIO+ - Managing the Measurement Data

EN
10
Managing the Measurement Data
Saving Data
• Press «Save» to store the measurement results, including
measurement mode, date, and time. If you do not wish to keep a
measurement, press «Cancel».
• To store measurement results from other blood pressure devices, go
to «Manual Input».
☞
The amount of data saved depends on the memory capacity of your
iOS device. A warning message will appear when the memory is full.
Delete old data to save new data.
Deleting Data
• Delete Individual Data: Go to «Report» and press «Edit».
• Delete All Data: Go to «Settings» and press «Reset Data».
Viewing Data
Go to «Report» to view data.
• Viewing Individual Data: Swipe the screen vertically to see data
taken in the same month. To view data taken in different months,
swipe the screen horizontally.
• Viewing Data in a Line Graph: Turn the iOS device horizontally. To
view data in a specic timeline, choose the intended period of view.
• Viewing Data in a Bar Chart*: Turn the iOS device and swipe the
screen horizontally. To view data in a specic timeline, choose the
intended period of view.
1D – One day
1W – One week
1M – One month
3M – Three months
1Y – One year
All – All measurements stored
Sharing Data
Go to «Report» and press « » to share data*.
*Data is shared via email in CSV format. To use this function, an email
account must be set up in your iOS device and an Internet connection
is needed.