8) Repeat measurements in the case of an
error – The device will automatically repeat the
measurement after a two minute countdown
should an error occur during measurement.
9) Storing measurement data – The WatchBP O3
automatically stores each measurement result,
along with the measurement date and time.
A total of 144 measurements can be stored in
«AMBULATORY» mode.
A repeat
measurement
is performed
automatically if
an error occurs.
*
If the repeat measurement encounters an error, the device will
stop taking measurements. The patient should return the device
to the physician to determine the cause of error.
*
The display of BP reading and memory of Ambulatory Mode
can be disabled via software setting.
144
Measurements
To Next Page
Loading...
