EN
34
Error Description Potential cause and
remedy
«Er 1»
Signal too
weak
The pulse signals
on the cuff are too
weak. Re-position the
cuff and repeat the
measurement.
«Er 2»
Error signal
During the
measurement,
error signals were
detected by the cuff,
caused for instance by
movement or muscle
tension. Repeat the
measurement, keeping
your arm still.
Error messages
If an error occurs during measurement, the
measurement is interrupted and an error
message «Er» is displayed.
Please consult your doctor, if
this or any other problem occurs
repeatedly.
If you think the results are
unusual, please read through
the information in this
instruction manual carefully.
To Next Page
Loading...
