MICROLIT SCITUS - User Manual

Questions and Answers

T
teresastricklandJul 28, 2025
Why do air bubbles appear in my MICROLIT Dispenser?
- A
  Amanda IbarraJul 28, 2025
  If air bubbles appear in your MICROLIT Dispenser, it could be due to several reasons. One reason is that the reagent with high vapor pressure has been drawn in too quickly, so you should draw the reagent slowly. Other reasons include: the instrument has not been primed (prime the instrument), the filling tube is loose or damaged (push the filling tube on firmly, and if necessary, cut off approx. 1 cm of the tube at the upper end and then re-connect it or replace it), the liquid reservoir is empty (refill reservoir and prime the unit), the filling action is too fast (fill and dispense slowly), the piston is leaking (clean the piston, and if the problem persists, replace it), or the discharge valve is leaking (clean by flushing thoroughly with distilled water).
M
Mark JohnsonAug 3, 2025
What to do if dispensing is not possible with my MICROLIT Dispenser?
- C
  Courtney FreemanAug 3, 2025
  If dispensing is not possible with your MICROLIT Dispenser, the dispensing nozzle might be blocked. To resolve this, disassemble the dispensing nozzle and flush thoroughly with distilled water. Another cause could be that the discharge valve is stuck, in which case you should clean the unit by immersing the valve assembly in distilled water.
M
Ms. Casey StephensAug 8, 2025
Why is the barrel not filling with liquid in my MICROLIT Dispenser?
- E
  Edwin MaysAug 8, 2025
  If the barrel of your MICROLIT Dispenser does not fill with liquid, it might be because the inlet tube is not fitted firmly. Make sure to connect the inlet tube correctly.
S
Sandra McdanielAug 16, 2025
How to calibrate my MICROLIT Dispenser if the dispensing volume is wrong?
- T
  Tonya CharlesAug 16, 2025
  If the dispensing volume of your MICROLIT Dispenser is wrong, it is likely that the instrument is not calibrated. Follow the user calibration steps to calibrate it.
S
stephanie27Aug 21, 2025
What to do if the piston is difficult to move in my MICROLIT Dispenser?
- L
  Lisa NelsonAug 21, 2025
  If the piston in your MICROLIT Dispenser is difficult to move, it could be due to the formation of crystals or deposition of dirt. Stop dispensing immediately. Loosen the piston in a circular motion, but do not disassemble it, and follow the cleaning instructions.