46
Audio Options Menu
Configures and reports the status of the audio hardware built into
your system.
Multimedia device: [Enabled] default
Configure the sound device and joystick.
Disabled
Enabled
Sound: [Auto] default
Configure the sound device.
Auto
Disabled
Enabled
DMAchannel: DMA 0, DMA 1, DMA 3, DMA5
Interrupt: IRQ5, IRQ7, IRQ9, IRQ10, IRQ11
Base I/O address: 220-22F, 240-24F, 260-26F, 280-28F
MPU I/O address: 300-301, 330-331
Joystick : [Enabled] default
Configure the joystick.
Enabled
Disabled
Plug & Play O/S: [No] default
Yes
No
Tells your system to expect a Plug-and-Play operating system
like OS/2.
Note:
Your Microsoft Windows 95 operating system will
automatically detect the PNP BIOS and work in either “Yes”
or “No” setting.
Mode: [Bi-Directional] default
Bi-Directional
EPP
ECP
Output Only
Base I/O address: 378 IRQ5, 378 IRQ7, 278IRQ7
3BC IRQ7, 278 IRQ5, 3BC IRQ5
Disabled
Chooses parallel (printer) port mode. Bi-directional works with
most printers, ECP (Extended Capabilities Port) is fastest, most
capable setting if your parallel device supports ECP mode.
EPP supports daisy-chained printer devices.
Pick-a-Point: [Pad] default
Pad
Stick
Disabled
Selects the pointing device. System uses one pointing device at
a time. Pad is the Touch Pad, Stick is the blue Pointing Stick. To
use a serial mouse, you must first set Pick-a-Point to disabled.
Modem configuration: [Auto] default
Selects modem configuration.
Auto
Disabled
Enabled
Base I/O Address: 3F8, 2F8, 3E8, 2E8
Sets the I/O Address for the modem.
Interrupt: IRQ3, IRQ4
Sets the interrupt for the modem.
To Next Page