User Guide
9
Chapter 4. Configure EasyMesh
This chapter introduces how to configure EasyMesh.
It chapter contains the following sections:
The Steps to Configure EasyMesh
How to Check the Device Information in Topology
4.1 The Steps to Configure EasyMesh
Step 1: set up the Controller
In the router management interface connected to the upper-level gateway (optical modem),
select "Network—EasyMesh—General", in the general settings page:
Fill in “Mesh Controller” in “Device Name”.
Select “Controller” in "Role".
Click "Save & Apply" interface button.
To Next Page
Loading...
