Micronta 22-185A - Making Measurements; DC;AC Voltage Measurements

MAKING
MEASUREMENTS
DC/AC
Voltage
Measurements
Important: The maximum input limit for voltage
measurement is 1000 V/DC and 750 V/AC (RMS). If
you attempt to measure DC voltages above 1000 volts
AC volts above 750 volts RMS, your unit may be
damaged. All the figures on the display will blink when
more than the maximum rate (DC 1000 V/AC 750 V) is
supplied: DISCONNECT PROBES IMMEDIATELY.
1. Set the function switch to DC V or AC V.
2. Set the range switch as required for the voltage level
to be measured. If you do not know the voltage level,
start with the range switch set to the highest position
and reduce the setting as required to obtain a
satisfactory reading.
18