Microplex SOLID F40 - Page 139

Troubleshooting 139
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F40 Edition 1.1
8.3.3. Paper Jam within the Power Stacker
There are different kind of troubles possible within the power
stacker (see section 8.2.1: Error codes , too). Frequently the folding
of the paper has not worked right and so a paper jam might result.
Press the table down switch to lower the paper table. Then shift the
paper table up to remove the flaw.
Sometimes it is also necessary to remove the paper from the stacker
or refinish the folding at the perforation and file the paper by hand.
This error described above is displayed by the message
[STACK ERROR! ]
[E0055 ]
Please inform your service engineer if there are any troubles
different from the one above.