Microplex SOLID F40 - Choosing Print Resolution

46 Panel Functions
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F40 Edition 1.1
5.3. Choosing Print Resolution
This function allows the user to choose the current print
resolution.
If, after a particular resolution is chosen, the print data stream
indicates a different resolution (e.g. via a WINDOWS print
driver), the second print resolution will be used only for that job.
ON LINE
SAVE
SAVE
SAVE
MENU
SAVE
ON LINE
Panel display
[SOLID F40 ]
[Menu Level 1
]
) ) )
[Engine ]
[Resolution ]
[300 dpi ]
) ) )
[600 dpi ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
Press one of the ARROW keys until
[Engine ] is displayed.
Menu item Engine is selected.
Menu item Resolution is selected.
Press one of the ARROW keys until
the desired Resolution (e.g. 600
d
ots per inch) is displayed.
600 dpi resolution is selected.
In addition this new value can be
saved as setup value (using the
SAVE key), before the printer is
turned ON LINE again.