Microplex SOLID F40 - Page 66

66 Panel Functions
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F40 Edition 1.1
5.18. Setting to Factory Default
This function back-outs all configurations to factory defaults.
ON LINE
SAVE
SAVE
MENU
SAVE
ON LINE
Panel display
[SOLID F40 ]
[Menu Level 1 ]
) ) )
[Configuration ]
[Interface ]
) ) )
[Factory Default ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
Press one of the ARROW keys until
[Configuration ] is displayed.
Press one of the ARROW keys until
[Factory Default ] is displayed.
Only if you press the SAVE key a
second time the configuration will be
back-outed to factory defaults.
The printer is turned ON LINE
again.