EasyManua.ls Logo

Microsemi Adaptec ASR-8805E - Installing on Vmware; Installing on Citrix Xenserver

Microsemi Adaptec ASR-8805E
92 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3. Insert and mount the driver disk (assuming the USB drive is /dev/sda1):
mount /dev/sda1 /mnt/usb
4. Install the DEB driver package (where xxxxx is the build number):
Ubuntu 11:
sudo dpkg -i
/mnt/usb/aacraid-1.2.1-xxxxx-Ubuntu11.10+12.04+12.04.1+12.04.2-all.deb
Ubuntu 14:
sudo dpkg -i /mnt/usb/aacraid-1.2.1-xxxxx-Ubuntu14.10-x86_64.deb
Ubuntu 16:
sudo dpkg -i /mnt/usb/aacraid-1.2.1-xxxxx-Ubuntu16.10-x86_64.deb
5. Reboot your computer to ensure the driver loaded correctly.
6. Continue with Managing Your Storage Spacetopic.
8.6 Installing on VMware
Note: You must remove the old driver before you can install the new one. You must have
root privilege to install the new driver.
Note: To copy the driver VIB le to the VMware ESXi server (in [ 2 ] below), you must
have access to a remote copy utility, such as WinSCP, putty, or Linux scp.
To install the driver on VMware:
1. At the VMware console screen, type these commands to remove the old driver from a VMware system:
esxcli software vib list | grep -i aacraid (list driver packages)
esxcli software vib remove --vibname=scsi-aacraid --maintenance-mode (remove
package)
2. Using a remote copy utility, copy the driver VIB le for your operating system version to a local directory
on the ESXi server. This example uses Linux scp to copy the driver to /tmp/aacraid (where xxxxx is the
build number):
scp
/mnt/sda1/linux/driver/vmware-esxi-drivers-scsi-aacraid-600.6.2.1.xxxxx.-1.0.6.2159203.x86_64.vib
root@<esx-server-ip>:/tmp/aacraid
3. Install the VIB module (where xxxxx is the build number):
esxcli software vib install -f -v
file:/tmp/aacraid/vmware-esxi-drivers-scsi-aacraid-600.6.2.1.xxxxx.-1.0.6.2159203.x86_64.vib
4. Reboot your computer.
8.7 Installing on Citrix XenServer
Note: To copy the driver RPM le to XenServer (in [ 1 ] below), you must have access to
a remote copy utility, such as WinSCP, putty, or Linux scp. You must have root privilege
to install the driver.
35
Microsemi Proprietary and Condential. Installation and User's Guide Revision 5
Installing the Driver on an Existing Operating System

Table of Contents

Related product manuals