28 M1179886
7. Install C-cover Screws – Close the AB-cover. Turn the unit over and use a 5IP screwdriver to install 4 new
screws to secure the C-cover. Screws should be installed until just snug and seated, and then turned another
45 degrees (1/8 turn) or until fully fastened.
8. Run SDT – Run SDT to ensure all device features and functions operate as expected. Refer to (page 17) for
details on SDT.
9. Install Feet – If SDT tests pass and no further repairs are to be performed on the device, follow steps for
Procedure – Installation (Non-Skid Feet) on page 17.
To Next Page
Loading...
