Microsoft Surface Hub 55 inch - Specifications

©2015 Microsoft. Microsoft, the Microsoft logo, and the Microsoft Surface Hub logo are trademarks of the Microsoft
group of companies. Microsoft Corporation One Microsoft Way Redmond, WA 98052-6399 USA
This document outlines the steps for assembling the Surface Hub 55” and Surface Hub 84”
rolling stand. These stands require two people to assemble. Before beginning, make sure you
have all of the components in the parts list.
IMPORTANT: Avoid damage to your device. The Surface Hub 55” is intended to be supported
only by its bottom edge when not supported by the mounting system. Rest it only on its bottom
edge, and support it to keep it vertical. The Surface Hub 84” is intended to be supported only by
the lifting handles when not supported by the mounting system. Do not place either device on
its face, back, top, or sides.
Specifications
Model
Device
weight
Stand
weight
Handle
weight
Designated
load capacity
Surface Hub 55”
110 lb.
270 lb.
NA
380 lb.
Surface Hub 84”
260 lb.
270 lb.
30 lb.
560 lb.
Required tools (not included)
#2 Phillips screwdriver
5mm hex key (55” only)
6mm hex key (84” only)
13mm wrench