10
The user can select the flash time (100ms, 300ms, 600ms and 1000ms) to meet your telephone line or
PABX requirement. The default is 100ms.
1) Press SET/OK key, then using ∧ or ∨ key to select FLASH TIME item.
2) Press SET/OK key to enter.
3) Press ∧ or ∨ key to select the desired flash time among 100ms, 300ms, 600ms and 1000 ms.
4) Press SET/OK key to confirm your selection.
To change the PIN code
Some functions (including handset delete and default) require a PIN code. The default PIN is 0000, but
you are able to change to your personal 4-digit PIN.
1) Press SET/OK key to confirm. Then using ∧ or ∨ key to select MODIFY PIN item.
2) Press SET/OK key to confirm, and the display shows PIN?
3) Entry the existing PIN code for the handset by using numerical keys (the default PIN code is 0000),
then press SET/OK to confirm.
4) If you enter the wrong PIN at any time you will hear an error tone and the display will return to the
previous menu.
5) If the old code is validated, the display shows NEW PIN, enter a new PIN code (4 digits), press
SET/OK to confirm.
6) The display shows REPEAT, input the new PIN code again.
7) Press SET/OK to confirm, the code will be stored and a tone sounded.
To default base settings
This function allows the user to restore the base settings to the factory default.
1) Press SET/OK key, then using ∧ or ∨ key to select BS DEFAULT item.
2) Press SET/OK key to confirm.
3) The user will be prompted to enter the PIN code, the display shows PIN?, then press numeric keys to
input code (default as 0000).
4) Press SET/OK key to confirm, if the PIN code is validated all base settings will be returned to the
factory default.
Handset Menu function 4: HS SETTINGS
The user is able to change a number of the settings for the handset to their own individual preferences. In
standby mode, press SET/OK key and use ∧ or ∨ key to select HS SETTINGS. Then you can do below:
Alarm
The user can set the alarm on the handset and adjust the alarm settings, to give an alert at a
programmed time of every day.
1) Press SET/OK key, the first sub-menu is ALARM item.
2) Press SET/OK key to confirm.
3) Press ∧ or ∨ key to select ON or OFF, press SET/OK key to confirm. Selection of OFF will turn
the alarm off, and the user is dropped back to the ALARM menu surface, selection of ON option will
turn the alarm on, then the user will be requested to set the alarm time.
4) After select ON, press SET/OK key to start the time settings of alarm, “12-00 AM” displayed with “12”
is blinking.
5) Press ∧ or ∨ key to change the hours, press SET/OK key to confirm, and setup the minutes and
To Next Page
Loading...