electrical socket. (A UK-compatible
connector is included, if required.)
2. Place the rechargeable NiMH BATTERY PACK
(part No. FA-BP) in the battery compartment
(see “Battery Installation”).
3. Place the RADIO in the charger base.
The CHARGE light on the charger base will indicate when the
radio is inserted into the charger properly.
A full charge will take approximately three (3) hours. You can
leave the unit in the charger indefinitely.
NOTE: Your microTALK
®
radio can also be operated with four
standard AAA alkaline batteries.
WARNING: Only the NiMH battery pack FA-BP can be recharged.
To Recharge the Rechargeable NiMH Battery Pack:
1. Attach the POWER SUPPLY to the charger base and plug it
into an electrical socket. (A UK-
compatible connector is included, if
required.)
2. Insert BATTERY PACK GUIDE in the radio
charging well.
3. Place the rechargeable NiMH BATTERY
PACK (part No. FA-BP) in the charger base.
The CHARGE light on the charger base will indicate when the
rechargeable NiMH battery pack (part No. FA-BP) is inserted
into the charger properly.
A full charge will take approximately three (3) hours. You can
leave the the battery pack in the charger indefinitely.
NOTE: Your microTALK
®
radio can also be operated with four
standard AAA alkaline batteries.
WARNING: Only the NiMH battery pack FA-BP can be recharged.
OPTIONAL
ACCESSORIES
For accessory orders and availability,
please contact your local dealer.
PA-BC2 ........Replacement Belt Clip
FA-BP ..........NiMH Rechargeable Battery
Pack
MA-SM ........Lapel Speaker/ Microphone
MA-VOX ......VOX Headset Speaker/
Microphone
MA-EBM ......Ear Bud Microphone with
Push To Talk Button
WARRANTY &
CUSTOMER
SERVICE
For warranty and customer service
information, please contact your local
dealer.
OPERATION
Product Information
This microTALK
®
radio has been manufactured to meet all
required standards for radio equipment using PMR 446
frequencies as authorized. The use of this two-way radio product
involves the public airways and its use may be subject to local
laws or regulations. Contact your radio licensing authority for
more information.
Caring for Your Radio
Your microTALK
®
radio will give you years of trouble-free service
if cared for properly. Here are a few suggestions:
• Handle the radio gently.
• Keep it away from dust.
• Never put the radio in water or in a damp place.
• Avoid exposure to extreme temperatures.
Product Features
• Two-Way Radio
with up to a 3 km (2 mile) range
•
8 Channels*
•
38 CTCSS Privacy Codes
• 83 DCS Codes
• Backlit LCD Display
•
Water Resistant
• Battery Saver Circuitry
•
Maximum Range Extender
•
VOX Mode for Hands-Free Transmissions
•
VibrAlert
®
Silent Paging
•
Intercom Capability
•
10 Memory Locations
• Call Alert (10 Selectable Tones)
•
Scan (Channel, CTCSS Privacy Code,
DCS Code, Memory)
•
Dual Watch Programmable 2-Location Scan
•
Key Lock
• Auto Squelch
• Selectable On/Off "Roger Beep"
Confirmation Tone
• Selectable On/Off
Keystroke Tones
• External Speaker/Microphone Jack
•
Belt Clip
• Wrist Strap
• Battery Charge Contacts in Battery Compartment Door
•
Rapid Desktop Charger
• Rechargeable NiMH Battery Pack
• AC Adapter (220V, 2-Pin Euro Plug)
•
Plug Converter
(220V, 2-Pin Euro Plug to 240V, 3-Pin UK Plug)
*You are not allowed to use channels 1 and 2 in France.
This situation can change; please contact the French radio
licensing authority for more information.
Battery Installation
To Install or Replace Batteries:
1. Remove belt clip by releasing belt clip
latch and sliding clip Up.
2. Pull down on the BATTERY DOOR LOCK
TAB to remove the battery
compartment cover.
3. Insert the rechargeable NiMH battery
pack (part No. FA-BP) according to
instructions indicated on battery pack.
4. Replace battery compartment cover
and belt clip.
NOTE: Your microTALK
®
radio can also be
operated with four standard AAA
alkaline batteries. Always use high-
quality alkaline batteries. Position
batteries according to polarity
markings.
NOTE: See “Optional Accessories” for accessory availability and
ordering instructions.
Battery Pack
and Desktop Charger
Your microTALK
®
radio includes a
rechargeable NiMH battery pack (part No.
FA-BP) and a rapid desktop charger (part
No. PA-CX). In addition, a UK-compatible
connector is included, if required.
Your rapid desktop charger is capable of recharging one (1)
radio (with battery pack installed in battery compartment) or
one (1) battery pack using the included battery pack guide in
the radio charging well. See “Optional Accessories” to order
additional rechargeable NiMH battery packs (part No. FA-BP) or
other speaker/microphone accessories.
You should fully charge the included rechargeable NiMH battery
pack (part No. FA-BP) before using your microTALK
®
radio for
the first time.
To Recharge the Rechargeable NiMH Battery Pack
In Radio:
1. Attach the POWER SUPPLY to the
charger base and plug it in to an
FA-BP
Remove Belt Clip
Lock Tab
Insert Batteries
To Next Page
Loading...