Microtek ScanMaker 3880 - Rear View and Accessories

3
Rear View OF ScanMaker 3880
Accessory of SM 3880 : LightLid-35 ( P/N :1108-03-520041 )
If your SM 3880 equips with LightLid 35 for film scanning, then we suggest you to do Lightlid 35
calibrator before you start ScanWizard to scan slide / negative film with Lightlid 35 for better quality.
USB 2.0 interface
connector *1
Power jack of scanner
( 12Vdc / 1.25A )
Power Label
( P/N : 219-21-820000 )
15 pin conne
ctor
for LightLid 35
The Label of scanner S/N.
Attention Tag for power use
LightLid 35
Calibrator is an
AP and support
to do lamp
calibration for
your LightLid 35.
Left illustration is
a windows
message after
you start
LightLid 35
calibrator. You
can click
“ calibrate “ to
do lamp
calibration after
lamp in Lightlid
35 is warmed up
for 3 minutes.