Microtek ScanMaker 4 - D) Using the 6 X 9 CM Batch Film Holder

17
English
4" x 5" Batch Film Holder
Main Holder
6 x 9 cm Batch Film Holder
Main Holder
4. Place the 4" x 5" Batch Film Holder in the Main
Holder, then put this assembly in the
transparency tray of the ScanMaker 4.
d) Using the 6 x 9 cm Batch Film Holder
1. Push to open the 6 x 9 cm Batch Film Holder.
2. Place the film to be scanned in the 6 x 9 cm
Batch Film Holder.
3. Pull to close the template.
4. Place the 4" x 5" Batch Film Holder in the Main
Holder, then put this assembly in the
transparency tray of the ScanMaker 4.