bread does not slip off the kneading paddles, carefully remove the kneading paddles
using the enclosed kneading paddle remover.
Note
Do not use any metal objects that may lead to scratches on the non-stick coating. After
removing the bread, immediately rinse the bread pan with warm water. This prevents
the kneading paddles from sticking to the driving shaft.
Tip: If you remove the kneading paddles after the last kneading of the dough, the
bread will remain intact when you remove it from the bread pan.
• Briefly press the Start/Stop button, to interrupt the baking process or pull the power
plug out of the wall socket.
• Open the appliance lid and take out the bread pan. You can take the dough out with
floured hands and remove the kneading paddles.
• Replace the dough and close the appliance lid.
• Push the plug back into the wall socket and press the “Start/Stop” button. The baking
programme is continued. Let the bread cool for 15-30 minutes before eating. Before
cutting bread, make sure that no kneading paddle is still in the bread pan.
Warning
Do not attempt to start operating the bread maker, before it has either cooled down or
warmed up. If the display shows “HHH” after the programme has been started, it
means that the temperature inside of bread pan is too high. You should stop the
programme and unplugged the power outlet immediately. Then open the lid and let the
machine cool down completely before using again.
If the display shows “LLL” after the programme has been started, it means that the
temperature inside of bread pan is too low. You should place the bread maker on a
higher environment for using.
If the display shows “EE0” after you have pressed “Start/Stop” button, it means the
temperature sensor open circuit, please check the sensor carefully by Authorized
expert. If the display shows “EE1”, it means the temperature sensor short circuit.
11. Making yoghourt
(1). preparing for use
a:Equipment required
Take the yoghourt container out ， then clean the container ，the lid inside and outside
with hot water. Sterilize with boiled water ， then use soft damp cloth to wipe the
surface of the yogurt container inside and outside.
b.Ingredients Preparation
To Next Page
Loading...
Need help?
General
