19 20
MAINTENANCE
As necessary, approx. once every 2 months,
remove the fluff from the heat exchanger
using the sponge or soft brush.
When doing this, please use gloves.
•
•
Clean heat exchanger
MAINTENANCE
extension of drying time and energy consumption.
• Do disconnect the power cord before cleaning!
• Do not operate the dryer without the filter!
• Clean the filter after each use to prevent lint accumulation inside the dryer.
• The fluff accumulated on the filter will block the air circulation, which will cause the
Note!
first dampened.
• The fluff can be removed more easily if it is
Note!
Trouble Shooting
“ ”E32
“ ”E33
Dispiay
Reason
Solutions
P lease contact your
local service center
if the problem
persists
Humidity sensor error
Temperature sensor error
• Only authorised technicans can carry out repairs.
• Before you call service,
fault yourself or if you have followed the user instructions.
• A technician will charge you for advice, even during the warranty period.
please check if you have dealt with the
If you cannot deal with the fault by yourself and need help:
• Press the 【On/Off】button.
• Pull out the mains plug and call the service.
Warning!
！
Warning!
！
• Clean lint filter and .
• Empty container.
• Check drain hose.
• Dryer installation place is too restricted.
• Clean the moisture sensors.
• Keep the Air inlet clean.
• Use higher drying intensity level programme or
time programme.
heat exchanger
• “ ”is lighting
•“ ”is inglight
Problem
Solution
•Display does not
on
• Check if the power supply works.
• Check if the mains plug is inserted.
• Check the selected programme .
• Press the 【On/Off】button.
• Empty water container.
• If the light is still on, please call the service.
• Clean heat exchanger.
• Clear lint filter.
•Dryer does not start
• the door has closed.
• Check the programme has set.
• Check the start button has selected.
Check the
•Degree of dryness was
reached or drying time too
long
not
To Next Page
Loading...
Need help?
General