OPERATIONS OPERATIONS
13 14
Programme selector
Other Functions
• of the 【Delay】function
Instructions
1. When the LED display screen brightens up, rotate
the programme knob to select the desired programme.
2.Select the【Delay】,【Time】,【Intensity】,【Anti-Crease】or【Signal】
functions for additional option.
3.Press the【Start/Pause】key.
Press the 【On/ Off】button.
Programme start
Programme end
1.The drum will stop running after the programme ends, the display will show " ",
the state light of "End" and related light will illuminate. The dryer will start
Anti-crease function if user doesn’t remove the load in time (refer to page 15).
Please press key to cut off power and pull the plug out.
2.Deal with the problems accroding to “Malfunction display and solutions , if there
is an unexpected stop during the drying procedure and the dryer show information
(refer to page 18 ).
【 】
【On/Off】
”
The drum will keep rotating after the programme starts, the state light in the display
area will flash in sequence, the remaining time displayed will change automatically.
This function is used for delaying clothes drying time within
24 hours. The delay
time means the programme will start after x hours. When the delay programme
starts, the time starts to decrease on the display and the delay icon blinks.
Steps in details:
1.Load your laundry and make sure the machine door is closed.
2.Press the 【On/Off】button,then to turn the programme selector knob and
select a desired programme.
3.You can select the 【Anti-Crease】or【Signal】functions according to your need.
4.To press the【Delay】 key.
5.Continue to press the 【Delay】to select the delay time.
6.After the 【Start/Pause】 key is pushed, the Dryer is at the run condition.
The drying procedure will be automatically performed when the delay time is over.
7.If you push the【Start/Pause】button again, the delay function will be paused.
8.If you want to cancel the “Delay” function, please press the 【On/Off】button.
Fliter
Please clean the filter when the“ ” is lighting, after the dryer stops.
Tank
Please empty the container when the“ ” is lighting, after the dryer stops.
On/Off
Product is switched on or off.
1
1
Start/Pause
the button to start or pause the
drying cycle.
Press
1
2
Specialty function
These buttons are used for setting
additional functions.
3
Display
This display shows the settings, estimated
remaining time and status messages of
your dryer.
4
Programmes
Different Dryer cycle can be selected
according to the user's needs to make the
clothes have more effective drying result.
5
Delay start
Child lock
Remaining Time indicator/Error message
Cycle phase status
Clean filters (warning)
Empty water container (warning)
Dryness level (four grades)
Drum lamp indicator
Signal indicator
Anti-crease mode
Time
My cycle
To Next Page
Loading...
Need help?
General