Foot installation:
Install four pieces of casters on the base panel (see drawing A)
(A)
Gas range installation
1> Leave at least 80 to 85cm between the top of the gas range and
any cabinet or range hood (including provisions for built-in range
hoods) installed above the unit.
2> Install the chain at the back of the oven, to the wall.
3> Make sure not to block the oven gas exit holes, including the
funnel or the gas vents, when you install the oven.
Gas installation
1>This range was designed for use with LP gas.
2> Always use a pressure regulator exclusively for your gas range
and LPG tank. Install only pressure regulators for household use.
An inadequate pressure regulator might cause excessive pressure
and gas leak. Always check for the validity period of the pressure
regulator. Hose and regulator should be replaced every 5 years.
·Pressure: 275 C.A.
·Max. consumption: 2kg/h
. does not have joints
Be sure that the hose:
. does not go to the back of the gas range and does not go near
the hot air exhaust holes at the back of the unit.
. is less than 125cm long
4> If possible, install the gas cylinder outside the kitchen, in a place
with good ventilation.
5> Use a
½”
metallic hose to connect to the gas range.
6> Only use a plastic hose when it does not go to the back of the
gas range.
Hose installation
1> Place the metal clamp at the hose end.
Chain
Bracket
Rubber
cushion
Applicable for
FP-63GSR060MMGO-T1
4>The metal bracket or cushion rubber must be
heat of the rear cover can escape smoothly.
that the
to ensure
To Next Page
Loading...
