Midea FZ10-19BRA

Note
Please place the machine on the package foam or other soft surfac-
es and invert it to avoid scratch mark when install the base.
1
Take out the two parts of the base from packing box. Then, align the centers of the
two parts of the base and place them in a crossed form. Rotate one of the two
bases to align its hole site and make it stuck correctly.
2
Unload four screws from the machine body prior to installation of the base on the
machine body when combination lines of the base and the fan body are aligned
accurately. Afterwards, fix and tighten the base and the fan body by means of screws.
Screws
Take out
Assembly Instructions
Use Instructions
Machine Body Operation Instructions
Buttons on the machine body