Page 15 
How to operate your unit without 
the remote control
In the event that your remote control fails to 
work, your unit can be operated manually with 
The MANUAL CONTROL button located on 
the indoor unit. Note that manual operation is 
not a long-term solution, and that operating 
the unit with your remote control is strongly 
recommended.
BEFORE MANUAL OPERATION
Unit must be turned off before manual 
operation.
To operate your unit manually:
1.  Open the front panel of the indoor unit.
2.  Locate the MANUAL CONTROL button 
beside of the display screen.
3.  Press MANUAL CONTROL button 
4.  Close the front panel.
repeatedly to change modes as follows:
o
a) Once=AUTO mode(heat or cool, 24 C
b) Twice=COOL mode(switches off after 30
c) Three times=OFF
and auto fan speed)
minutes--testing purpose)
Manual Operation (Without Remote)
5
 CAUTION
The manual button is intended for testing 
purposes and emergency operation only. Please 
do not use this function unless the remote is 
lost and it is absolutely necessary. To restore 
regular operation, use the remote control to 
activate the unit.
Manual Operation 
(Without Remote)
Manual control button
 Page 14 
How to Use 
Advanced 
Functions
The following situations may affect the detection result of the Intelligent Eye:
-- size of the room, thickness of the mosquito net, position of bed, double layer bed;
-- the children is less than one meter high;
-- obstacles between Intelligent Eye and bed;
--  a heating appliance in the conditioned space.
 
Press the EYE button to activate the intelligent eye function, press it again to stop. 
The system is controlled intelligently under EYE mode. First it goes into sleeping
operation by default, the set temperature and fan speed are automatically controlled.
After 20~30 minutes later, the system begins to sense the sleeping state of the children 
and goes into sleeping detection mode. If it detects the children kicking the blankets and
most part of the body exposing, the system will automatically adjust the set temperature, 
fan speed and the airflow direction of the horizontal louver to protect the children.
INTELLIGENT EYE FUNCTION
EYE
EYE
Effective Detection range of intelligent eye:
-- cover a level angle of 140 degrees,  a fan-shaped area with a radius of 4 meters;
-- the detection radius is determined by the air conditioner installation position. It is
   recommended to install the air condtioner at 220mm~250mm from the floor.
-- The lower the air contioner installs, the smaller distance the Intelligent Eye detects.
    Please place the bed near the air contioner If the bed is higher.
Air contioner
Air contioner
4 meters
Wall
Bed
4m
>2.2m
Scanned area
Suggested installation positions:(AC=air conditioner)
Not recommended installation positions:(AC=air conditioner)
AC
AC
AC
AC
AC
Bed
Bed
Bed
Bed
Bed