10
3. Timer off time must be longer than timer on time.
4. 0.5 second after setting, the wire controller send information.the setting is nished.
CHANGE TIMER
If there is a need of changing timer time, press corresponding button to revise it. If
concel timer, change timer time to 0.0.
NOTE
The timer time is relative time,that is delay after setting time
METHODS OF INDOOR UNIT ADDRESS SETTING AND QUERY
1. Long press the “LOCK” key for 5 seconds, enter into the indoor unit address setting
interface;
2. The temperature display area will display the address of the indoor unit
that last time the user adjusted, and represent the address you are going to set,
press “▲”and“▼ can change the address to you want, then press “Fan speed” key
to nish the indoor unit address setting.
3. After enter into the address setting interface, press “MODE” key to query the indoor
unit address.
4. Under the address setting interface, if there is no operation in 10 sec, it will
automatically quit the setting and exit the address setting interface.
WARNING: The non-professional do no operate
AUTO-RESTART
The wired controller has the auto-restart function, each time re-power on, it will a
utomatically display the status before powered off(ON/OFF, Running mode, setting
temperature, fan speed, locked or not), but the wired controller will not send control signal
to the indoor unit again.
To Next Page
Loading...
Need help?
General
