8) Disconnect the grounding
wire (yellow-green) after
removing the big handle and the
right-rear panel.
9) Remove the PCB board.
How to remove the compressor.
1) Perform work of item 1,2,3.
2) Remove the electrical
control box and partition
plate.
3) Extract refrigerant gas.
4) Remove the sound
insulation material and
crankcase heating cable.
5) Remove terminal cover of
compressor, and disconnect
wires of compressor thermo
and compressor from the
terminal.
6) Remove the discharge pipe
and suction pipe with a
burner.
7) Remove the hex nuts and
washers fixing the
compressor to bottom plate.
8) Lift the compressor.
To Next Page
Loading...
