How to remove the fan ass’y.
1) Remove the top cover, right
front side panel and front
panel from item 1.step 1~4
2) Remove the hex nut fixing
the fan.
3) Remove the fan.
4) Remove the electrical
control box cover.
5) Disconnect the fan motor
connector CN37(5p,white) from
the PCB board.
6) Remove the fan motor
after unfastening six fixing
screws.
How to remove the electrical
parts.
1) Perform work of item 1,2..
2) Remove the ten screws
fixing the IPM board.
3) Unfasten the connector
of the reactor.
4) Unfasten the connector
of the compressor.
To Next Page
Loading...
