Service manual for portable washer Midea America Company
-------------------------------------------------------------------------------------------------------------------------------------------------------
－ 16 －
Wash cycle
time is longer
than usual
The washer automatically
adjusts the wash time for the
amount of laundry, water
pressure and other operating
conditions.
This is normal. The washer adjusts cycle time
automatically to provide optimal results for the
selected cycle.
The time remaining shown in the display is only
an estimate. Actual time may vary.
Musty or
mildew odor
in washer
Incorrect or too much
detergent has been used.
Inside of tub was not cleaned
properly.
Use only High-Efficiency (HE) detergent in
accordance with the manufacturer’s
instructions. Run an Express cycle with bleach
once a month to clean tub and remove any
mold from inside washer.
Washer will
not turn ON
Power cord in not properly
plugged in.
House fuse is blown, circuit
breaker has tripped, or power
outage has occurred.
House fuse is blown, circuit
breaker has tripped, due to
multiple appliances on one
outlet.
Make sure that the plug is plugged securely into
a grounded,3-prong, 120-VAC, 60-Hz outlet.
Reset circuit breaker or replace fuse.
Do not increase fuse capacity. If the problem is
a circuit overload, have it corrected by a
qualified electrician.
Reset circuit breaker or replace fuse.
If more than one appliance is connected to the
outlet, call an electrician to have an additional
circuit installed.
Water leaks Over sudsing of detergent. Over sudsing may create leaks, and may be
caused by the type and amount of detergent
used.
High-Efficiency detergent is the only detergent
recommended. Make sure that detergent and
any additives are put into the correct dispenser
compartments.
The normal amount of detergent to use is 1/4 to
½ of the maximum amount recommended by
the detergent manufacturer. Always reduce the
amount of detergent if the load is small or lightly
soiled, or if your water is very soft.
Never use more than the maximum amount
recommended by the detergent manufacturer.
Poor stain
removal
Previously set stains. Articles that have previously been washed may
have stains that have been set . These stains
may be difficult to remove and may require
hand washing or pre-treating to aid in stain
removal.
Washer will
not drain
water
Kinked drain hose.
Drain located higher than 48 in.
above the floor.
Ensure that the drain hose is not kinked.
Make sure that the drain hose is no higher than
4 ft. above the bottom of the washer and is no
more than 5 ft. away from the washer.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
