Midea MAP08S1XWT - Page 29

29
If the memory feature is activated, “ ” displays for 3 seconds on the screen.
If the memory feature is stopped, “ ” displays for 3 seconds on the screen.
While the memory feature is activated, press the ON/OFF button, shift the mode or power
failure will not cancel the C-SENSE function.
SWING
How to Use Advanced Functions
Swing function(some units)
C-SENSE function(some units)
SLEEP function
Press Swing button
The horizontal louver will swing up and down
automatically when pressing Swing button.
Press again to make it stop.
Keep pressing this button more than 2 seconds, the
vertical louver swing function is activated.
(Model dependent)
SWING
2s
SLEEP
The SLEEP function is used to decrease energy use while
you sleep (and don’t need the same temperature settings
to stay comfortable). This function can only be activated
via remote control.
The sleep function is not available in Fan or Dry mode.
Please refer to the OWNER’S MANUAL for more details.
When the C-SENSE function is activated, the remote
display is actual temperature at its location.
The remote control will send this signal to the air
conditioner every 3 minutes interval until press the
C-SENSE button again.
OF
NOTE: Press this button for seven seconds to start/stop memory feature of C-SENSE function.
On
C-SENSE