Midea MAW12AV1QWT User Manual (English)

Questions and Answers:

L
lescobarAug 16, 2025
Why won't my Midea MAW12AV1QWT Air Conditioner start?
- N
  Nancy RiggsAug 16, 2025
  Your Midea Air Conditioner might not be starting due to several reasons: * The wall plug may not be properly connected. Ensure it's firmly pushed into the wall outlet. * The circuit breaker might have tripped. Try resetting the circuit breaker. * The power might be off. Turn the power on. * If the light on the plug is off, press the RESET button. * If the unit was recently turned off and on, turn it off and wait 3 minutes before restarting.
A
amy70Aug 18, 2025
Why is the air from my Midea Air Conditioner not cold enough?
- K
  Katherine BakerAug 18, 2025
  If the air from your Midea Air Conditioner isn't cold enough, it could be due to the following: * The room temperature might be below 62°F (17°C). Cooling may not be effective until the room temperature rises above this. * The temperature sensor behind the air filter might be touching the cold coil. Try to reposition it so it doesn't make contact. * The temperature setting may be too high. Reset to a lower temperature. * The compressor might have shut off due to changing modes. Wait approximately 3 minutes and listen for the compressor to restart when set in the COOL mode. * There may be obstructions blocking the outdoor intake/exhaust. Clear any obstructions.
S
seth53Aug 21, 2025
Why does my Midea MAW12AV1QWT turn on and off rapidly?
- C
  Christopher ScottAug 21, 2025
  Your Midea Air Conditioner might be turning on and off rapidly due to: * A dirty air filter restricting airflow. Clean the air filter. * Extremely hot outside temperatures. Set the FAN speed to a higher setting to increase airflow past the cooling coils. * Obstructions blocking the outdoor intake/exhaust. Clear any obstructions.
D
David DouglasAug 25, 2025
Why is the remote sensing deactivating prematurely on my Midea Air Conditioner?
- M
  Michael MartinezAug 26, 2025
  If the remote sensing on your Midea Air Conditioner is deactivating prematurely, it could be due to: * The remote control not being located within range. Place the remote control within 26 feet and a 180° radius of the front of the unit, pointed in the general direction of the air conditioner unit. * An obstruction blocking the remote control signal. Remove any obstructions.
B
Brian JamesAug 27, 2025
What to do if water is dripping inside my Midea MAW12AV1QWT when it's cooling?
- S
  shawn55Aug 28, 2025
  If water is dripping inside your Midea Air Conditioner when it's cooling, it's likely due to improper installation. Tilt the air conditioner slightly to the outside to allow for water drainage. Refer to the installation instructions or check with the installer.
C
carolinemartinezAug 30, 2025
What to do if my Midea MAW12AV1QWT is cooling but the room is too warm and there's no ice forming?
- G
  Grace MaddoxAug 31, 2025
  If your Midea Air Conditioner is running but the room isn't cooling down and there's no ice on the cooling coil, consider the following: * The air filter might be dirty or restricted. Clean the filter, referring to the Care and Cleaning section. * The temperature setting may be too high. Lower the temperature setting. * The air directional louvers might be positioned improperly. Adjust them for better air distribution. * The front of the unit could be blocked by drapes, blinds, or furniture, restricting air distribution. Clear any obstructions. * Open doors, windows, or registers might be letting cold air escape. Close them. * The room itself might be too warm. Allow more time for the unit to remove stored heat from the walls, ceiling, floor, and furniture.
T
Theresa ThomasSep 3, 2025
What to do if my Midea MAW12AV1QWT is cooling, but the room is too warm and ice is forming?
- T
  taylor54Sep 3, 2025
  If your Midea Air Conditioner is cooling, but the room is too warm and ice is forming on the cooling coil, here's what you can do: * If the outdoor temperature is below 64°F (18°C), set the unit to FAN ONLY mode to defrost the coil. * If the air filter is dirty, clean it. Refer to the Care and Cleaning section. You can also set the unit to FAN ONLY mode to defrost the coil. * If the thermostat is set too cold for night-time cooling, set to FAN ONLY mode to defrost the coil, then set the temperature to a higher setting.
A
Andrew RiveraSep 5, 2025
Why is my Midea Air Conditioner making noise when cooling?
- B
  Billy HenrySep 6, 2025
  The noise from your Midea Air Conditioner during cooling could be due to: * Normal air movement sound. If it's too loud, set the fan to a slower setting. * Window vibration due to poor installation. Refer to the installation instructions or check with the installer.
M
Mrs. Christina Hill DDSSep 9, 2025
How to make my Midea MAW12AV1QWT not so cold?
- G
  Gerald WashingtonSep 9, 2025
  If your room is too cold when using your Midea Air Conditioner, it's likely because the temperature setting is too low. Increase the temperature setting.
Q
qbradshawSep 12, 2025
What if the window does not insert into the U-shaped slot of my Midea Air Conditioner?
- A
  Alexander JohnsonSep 12, 2025
  Ensure that the 'U-shaped' slot is in line with the window; if not, align the slot with the window. Make sure that the unit is not slanted too much, as this may cause interference with the top of the unit. Reference the installation instructions for more information.

Midea MAW12AV1QWT Specifications

General

Type	Window Air Conditioner
Voltage	115V
Operating Temperature (Cooling)	62°F - 90°F
Refrigerant	R32
Cooling Capacity	12000 BTU
Heating Capacity	12000 BTU
Smart Features	Wi-Fi Enabled
Power Supply	115V/60Hz
Energy Efficiency Ratio (EER)	12.1