26
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and damages to the induction hob.
(2) Specific Failure & Solution
Failure Problem Solution A Solution B
No power supplied.
The accessorial power
board and the display
board connected failure.
The accessorial power
board is damaged.
The display board is
damaged.
The display board is
damaged.
Check to see if plug is
secured tightly in outlet
and that outlet is
working.
Check the connection.
Replace the accessorial
power board.
Replace the display
board.
Replace the display
board.
Pan detection circuit is
damaged, replace the
power board.
The LED does not
come on when unit is
plugged in.
High temperature of the
hob.
There is something
wrong with the fan.
The power board is
damaged.
Ambient temperature
may be too high. Air
Intake or Air Vent may be
blocked.
Check whether the fan
runs smoothly；if not ,
replace the fan.
Replace the power board.
The Cooking Mode
Indicator comes on,
but heating does not
start.
Pan Type is wrong.
Pot diameter is too small.
Cooker has overheated;
Use the proper pot (refer
to the instruction
manual.)
Unit is overheated. Wait
for temperature to return
to normal.
Push “ON/OFF” button
to restart unit.
Heating stops
suddenly
during operation and
the display flashes
“u”.
The power board and the
display board connected
failure;
The display board of
communicate part is
damaged.
The Main board is
damaged.
Check the connection.
Replace the display
board.
Replace the power board.
Heating zones of the
same side ( Such as
the first and the
second zone ) would
display “u” .
The fan motor is
damaged.
Replace the fan.
Fan motor sounds
abnormal.
Some buttons can’t
work, or the LED
display is not normal.
To Next Page
Loading...
