Only one setting is enabled between
"DAILY TIMER" and "WEEKLY
SCHEDULE". If any of the pattern in
"WEEKLY SCHEDULE" is set to ON,
"DAILY TIMER" is disabled. "DAILY
TIMER" can be setted across days, but
"WEEKLY SCHEDULE" can’t be.
Users can set up to two timers, and set the
ON or OFF time (set the interval of time to
10 minutes) 、operation mode(COOL
mode and HEAT mode ) and temperature
setting for each segment of timer.
When the cursor stays at “DAILY TIMER
1”,press "◄" and "►" to select “TIMER 1”
or “TIMER 2”. Press "▲" and "▼" to select
“DAILY TIMER 1”, ACT, “SILENT MODE”.
Press the"ON/OFF" button to enable or
disable daily timer function.
After MODBUS control and the remote
control of the external machine are used,
the daily and weekly time settings of the
wired controller are invalid, and users
cannot enter the timing menu for setting,
the daily timer and weekly schedule
promote “DISABLE” on the user
menu/time interface.
DAILY TIMER 2
OK
ACT
ON
SILENT
MODE
T.ON T.OFF MODE TEMP
10:00A 10:00A HEAT
40℃
SILENT
TIMER
OK
DAILY TIMER (DISABLE)
DATE AND TIME
WEEKLY SCHEDULE (DISABLE)
8
To Next Page
Loading...
Need help?
General