NOTE:
Press
"▼" and "▲"
to select "YES" or "NO",
and press "OK" to save the settings and
return the previous interface, while press
"BACK" to cancel the settings and return
the previous interface. Only settings sent
complete can set the next module when
returning to the settings interface.
"PARAMETER SETTING" is shown on
the interface when the send is not
completed while it will disappear after
sent. This only happens when T3 is below
0℃.
◆
Pump manual switch
The pump manual switch function is only
valid for the main unit.
If The main interface has shown boot, it
will show "Cannot Control The Pump
Before Shutting Down" after selecting
"PUMP MANUAL SWITCH" menu.
If the main interface shows shutdown, it will
enter the following interface to select pums.
PERFORM MANUAL DEFROST ?
NO
MANUAL DEFROST
OK
SERVICE MENU
HISTORY ERRORS QUERY
ok
STATE QUERY
MANUAL DEFROST
PUMP MANUAL SWITCH
PUMP MANUAL SWITCH
Cannot Control The Pump
Before Shutting Down.
ok
SELECT THE ADDRESS
00
PUMP MANUAL SWITCH
OK
19
11
To Next Page
Loading...
Need help?
General