3.6 Setting Wired Controller
Address
The set address range is 00 to 15.
Press the "MENU" and "►" buttons for 3s at
the same time to access wired controller
address selection, and press the "▲" and "▼"
buttons to select the desired values.If there is
no subsequent operation in 60s, the setting is
saved automatically, and the system returns
to the home page.Press the "BACK" button to
cancel the setting and return to the previous
interface.
SET ADDRESS
00
OK
MON 10：35A
If the system has a single pump, the default
choice is 00 pump. If the system has multiple
water pumps, each pump must be set.
Press "BACK" to return the previous interface.
Press "OK" to enter the enterface which can
select the address to force the pump on.
Press
"▼" and
"
▲"
to select "YES" or "NO",
and press "OK" to confirm, while press
"BACK" to cancel the settings and return to
the previous interface.
SELECT ON THE PUMP?
NO
PUMP MANUAL SWITCH
OK
SELECT THE ADDRESS
00
PUMP MANUAL SWITCH
OK
PARAMETER SETTING
Select "NO" and press "OK" to return to the
previous interface.
Select "YES" and press "OK" to force on
local address pump, and return to the
previous interface. The interface will prompt
"PARAMETER SETTING".
20
12
To Next Page
Loading...
Need help?
General