EN-10
5)Dismantle the door stop of the two door bodies and the self-locking screws of right door, then take
out the self-locking of left door from the accessory bag and install it to the left corner of the door body
together with the door stop; take out the bottom support block of the door body of refrigeration
chamber and install it to the lower left corner,Finally take out the hole plug and shaft sleeve for the
door of refrigeration chamber and adjust their positions, and then install them into the door body.;
take out the right decorative cover on the door of refrigeration chamber, and take out the left
decorative cover from the accessory bag and install it.
6)Install the door of refrigerator chamber on the lower hinge, the middle hinge on the left side of the
refrigerator and tighten the screws, and place the shaft sleeve well. Install the plug pin in the hole on
the middle beam at the other end.
Hole cap
sleeve pipe
Right decorative cover
Right decorative cover
Self-locking
of left door
Self-locking
of right door
Door stop
Support block
To Next Page
Loading...
Need help?
General
