Midea MDV-V160W/DN1 General Information

122 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

MCAC-VTSM-2013-12 R410a Full DC Inverter Mini VRF

General Information 1

Contents

Part 1 General Information ........................................................... 2

Part 2 Specifications & Performance ........................................ 11

Part 3 Installation ........................................................................ 74

Part 4 Troubleshooting ............................................................... 88

Manufacture reserves the right to discontinue, or change at any time, specifications or designs

without notices and without incurring obligations.

Библиотека СОК 

Other manuals for Midea MDV-V160W/DN1

Owner's Manual12 pages

Questions and Answers:

X
xcontrerasAug 16, 2025
Why is my Midea MDV-V160W/DN1 having a low cooling effect?
- K
  Kelly RamirezAug 17, 2025
  If your Midea Air Conditioner isn't cooling effectively, several factors could be at play. First, ensure that both the outdoor and indoor unit heat exchangers are clean. Next, check and clean the air filter. Make sure that the inlet and outlet of both units aren't blocked, ensuring smooth airflow. Close any open doors and windows, and use curtains to block direct sunlight. Reduce any excessive heat sources in the room. If the outdoor temperature is too high, the AC's cooling capacity may be reduced, which is normal. Finally, check for refrigerant leakage and recharge if necessary.
W
whitneyjonesAug 19, 2025
What to do if my Midea MDV-V160W/DN1 unit does not start?
- K
  Katie SellersAug 19, 2025
  If your Midea Air Conditioner unit isn't starting, it could be due to a few reasons. There might be a power failure, so wait for the power to come back on. The power switch might be off, so ensure it's switched on. The fuse of the power switch could be burned, or the batteries of the remote controller may be exhausted. In these cases, replace the batteries or check the controller.
B
Brenda ShieldsAug 22, 2025
Why does my Midea MDV-V160W/DN1 unit start and stop frequently?
- R
  Rebecca FlemingAug 22, 2025
  If your Midea Air Conditioner units start and stop frequently, several causes are possible. It could be that the refrigerant level is either too low or too high, requiring a check for leakage and a proper recharge. Air or non-condensing gas might be present in the refrigerating circuit, necessitating vacuuming and refrigerant recharge. The compressor might be malfunctioning, suggesting maintenance, replacement, or installation of a manostat. Additionally, voltage levels that are too high or too low, or a blocked system circuit, could be the cause, requiring investigation and resolution.
C
Chelsea PhillipsAug 25, 2025
What to do if my Midea MDV-V160W/DN1 Air Conditioner is flowing air normally but completely can't cooling?
- J
  Jennifer MezaAug 26, 2025
  If your Midea Air Conditioner is flowing air normally but not cooling, the temperature may not be set correctly; ensure you set it properly. Also, the compressor may be in a 3-minute protection mode, so simply wait.
U
ustewartAug 27, 2025
What to do if the Midea MDV-V160W/DN1 remote controller signal is not transmitted?
- J
  Joe WolfeAug 27, 2025
  If the remote controller signal isn't transmitting to your Midea Air Conditioner even when you push the ON/OFF button, check whether the batteries in the remote controller are exhausted. If so, replace them.
D
Dr. Craig ClarkAug 30, 2025
Why is my Midea MDV-V160W/DN1 having a low heating effect?
- T
  Timothy HancockAug 30, 2025
  If your Midea Air Conditioner has a low heating effect, it could be due to several reasons. If the outdoor temperature is lower than 7°C, consider using a heating device. Ensure that doors and windows are completely closed. Also, check for any refrigerant leakage or a lack of refrigerant, and recharge if necessary.
T
Taylor StewartSep 2, 2025
How to change the fan speed on my Midea Air Conditioner?
- S
  Sean BakerSep 2, 2025
  If the fan speed on your Midea Air Conditioner cannot be changed, check if the MODE indicated on the display is set to "AUTO". When automatic mode is selected, the air conditioner will automatically adjust the fan speed. Also, check if the MODE is set to "DRY". When dry operation is selected, the air conditioner also automatically changes the fan speed. The fan speed can be manually selected during "COOL", "FAN ONLY", and "HEAT" modes.
S
Susan DavisSep 4, 2025
Why doesn't the TEMP. indicator come on my Midea MDV-V160W/DN1 Air Conditioner?
- S
  Stephanie MartinSep 5, 2025
  If the TEMP. indicator does not come on for your Midea Air Conditioner, check whether the MODE indicated on the display is FAN ONLY. The temperature cannot be set during FAN mode.

Midea MDV-V160W/DN1 Specifications

General

Cooling Capacity	16.0 kW
Heating Capacity	18.0 kW
Power Supply	380-415V/3Ph/50Hz
Refrigerant	R410A
Indoor Unit Noise Level	42 dB(A)
Outdoor Unit Noise Level	56 dB(A)
Type	VRF

Related product manuals

Midea MDV-V160W/DN1(B)

Midea MDV-V160W/DVN1

Midea MDV-V120W/DN1

Midea MDV-V140W/DN1

Midea MDV-V100W/DN1

Midea MDV-V105W/DN1

Midea MDV-V180W/DN1

Midea MDV-V100W/DN1C

Preview: Midea MDV-V105W/DVN1

Midea MDV-V105W/DVN1

Midea MDV-V120W/DVN1

Midea MDV-V140W/DVN1

Preview: Midea MDV-V80W/DN1

Midea MDV-V80W/DN1