MCAC-2008-11 Air-cooled Modular Chiller
70
In this window, there are seven timing segments from “Time_set1” to “Time_set 7” for your setting. Click a
timing segment, and then click “Setting”, enter to this time parameter setting, window as follows:
Electricity control function description
LCD operation description
Query function
Click “Query” button at principal window, and then enter to query window. The address codes of on-line units
will show in this page in light blue. Click a light blue button, the page 1 of query window will be entered, click
“Main FG” back to principal window. At the page 1 of “Query window”, click “Next Fig” could enter to other
parameters setting pages; click “Next unit” or “Previous unit” could shift on-line units, click “Return” back to
principal window; click“ Check Error” or “Check Error record” button enter to malfunction query window, in
which, you could check the detail of the malfunction, additionally, increase or decrease the units number's
value could skips among the different units whose malfunctions could be showed. Selected a malfunction,
and click “Help”, system will enter into troubleshoot window providing some malfunction remove methods for
user. Click “Return” back to previous window.
Mode setting function
Click “Mode setting” in the principal window enter to Mode Setting window. Click “Run Way change” realizing
the transition between Manual Control Mode and Auto Control Mode. When switch to “Auto” mode, run unit
quantity will be shielded, i.e. in this mode, system will automatically deicide the operating unit quantity as per
capacity requirement, and drive up unit sequential according to their address from small to large. When
switch to “Manual” mode, you should input the quantity to “Run unit” (Such value cannot larger than actual
connected unit's quantity within the system.)
If the system already in operating, any set are unavailable, but shutdown, because operation cannot be
changed during operating.
If the system in close-down, press the “Mode set” button, the mode would be changed once a time, the
mode changed sequence as follows:
To Next Page
Loading...
Need help?
General