Fully built-in model
Place the hook on the decorative panel and insert the hook into the slot on the outside of the washing
machine door (picture A). After installing the panel, fasten it to the door of the washing machine with
screws (picture B).
AND
B
1. Remove the four short screws
2. Insert four long screws
Step 3 Adjusting the door spring tension
1.The door springs are adjusted to the appropriate
tension at the factory. If you are installing a
decorative panel, it is necessary to adjust the
tension of the door spring. Turn the adjusting
screw to tighten or loosen the steel cable.
2.The tension is correct when the door
remains horizontal in the fully open
position and lifts to the closed position with
ease, with one finger.
23
To Next Page
Loading...
