EasyManuals Logo

Midea MLH52S7AGS User Manual

Midea MLH52S7AGS
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
24
Washer
Safety
Operation
Requirements
Installation
Instructions
Washer Use
Washer Care
Troubleshooting
5. After the cycle is complete, leave the door open slightly for better
ventilation.
If for any reason the cycle needs to be interrupted, the door will not
open immediately. Forcing open the door at this stage may cause water
to flood. The door will open after the water is drained to a level where it
would not flood the floor.
Tub Clean may be interrupted by pressing the Pause/Add a Garment
button in between cycles. A power outage in the house might also
interrupt the cycle. When the power supply is back, the Tub Clean cycle
resumes where it had stopped. When interrupted, be sure to run a
complete Tub Clean cycle before using the washer. If the Power pad is
pressed during Tub Clean, the cycle will be lost.
IMPORTANT:
Run Tub Clean with 1 Cup (250 ml) of bleach once a month.
After the completion of a Tub Clean cycle, the interior of your washer
may have a bleach smell.
It is recommended to run a light color load after the Tub Clean cycle.
DISPENSER DRAWER AREA
Detergent and fabric softener may build up in the dispenser drawer.
Residue should be removed once or twice a month.
Lock tab is visible only after drawer has been pulled open.
Remove the drawer by first pulling it out until it stops. Then reach back
into right rear corner of the drawer cavity and press down firmly on the
lock tab, pulling out the drawer.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Midea MLH52S7AGS and is the answer not in the manual?

Midea MLH52S7AGS Specifications

General IconGeneral
BrandMidea
ModelMLH52S7AGS
CategoryWasher
LanguageEnglish

Related product manuals