Wireless Remote Controller MLCAC-UTSM-2010-10
132 Control
4 Lock display
Press LOCK to display the icon of LOCK. Press the button again then the icon of LOCK disappears. In
the mode of LOCK, all the buttons are invalid except for LOCK button.
5 CLOCK display.
Usually display the clock set currently. Press the button CLOCK for 4 seconds, the HOUR part will flash,
press button ▲ and ▼ to adjust HOUR. Press the button CLOCK again, the minute part flash, press
button▲ or▼ to adjust MINUTE. After clock set or clock operation, it must press CONFIRM to complete
the set.
6 TIMER ON/OFF display:
Display ON at the state of TIMER ON adjustment or after only set the TIMER ON; Display OFF at the
state of TIMER OFF adjustment or after only set the TIMER OFF; Display ON/OFF if simultaneously set
the mode of TIMER ON and TIMER OFF.
7 Temperature display area:
Usually display the set temperature. Press the buttons of and to set temperature, at the mode of FAN,
there is no figure display in the area.
NAME AND FUNCTIONS OF BUTTONS ON WIRE CONTROLLER
1 mode selection button:
It is used to select mode, push the button one time, then the operation modes will change
In turn as follows:
AUTO→ COOLING →DEHUMIDIFY →HEATING→ FAN
Remark: no heating mode if wire controller is set as the cool only.
2 Timer on button:
Push the button to set TIMER ON, each time you push the button the time moves forward by o.5 hours.
When the set time is over 10 hours, each time you push the button the time moves forward by 1 hour. If
want to cancel the TIMER ON, then adjust the time of TIMER ON as 0.0
To Next Page
Loading...
Need help?
General