24
-During dehumidifying modes, remove the drain plug from the back of the unit, install the drain
connector(5/8〞universal female mender) with 3 /4〞hose(locally purchased). For the models without
drain connector, just attach the drain hose to the hole. Place the open end of the hose directly over the
drain area in your basement floor. Please refer to Fig.17&18.
-During heating pump mode, remove the lower drain plug from the back of the unit, install the drain
connector (5/8 〞 universal female mender) with 3/4 〞 hose(locally purchased). For the models
without drain connector, just attach the drain hose to the hole. Place the open end of the hose adaptor
directly over the drain area in your basement floor. Please refer to Fig.19
NOTE: Make sure the hose is secure so there are no leaks. Direct the hose toward the drain, making
sure that there are no kinks that will stop the water flowing. Place the end of the hose into the
drain and make sure the end of the hose is level or down to let the water flow smoothly. Do
never let it up.
To Next Page
Loading...
Need help?
General
