26
EN
Problem Possible reason
Door seal fails to be
tight
• Remove foreign matters on the door seal
• Heat the door seal and then cool it for restoration (or blow it
with an electrical drier or use a hot towel for heating)
Water pan overflows
• 2!./0+'%*#ˏ+"ˏ0$!ˏ.!".%#!.0+.ˏ+.ˏ+*0!*0/ˏ+*0%*%*#ˏ0+ˏ
)1$ˏ30!.ˏ.1*+""ˏ.!ˏ.!(!/%*#ˏ0++ˏ)1$ˏ30!.
• The doors are not closed properly, resulting in frosting due to
entry of air and increased water due to defrosting
Hot housing
• Heat dissipation of the built-in condenser via the housing,
which is normal when housing becomes hot due to high
ambient temperature, storage of too much food or shutdown
of the compressor is shut down, provide sound ventilation to
facilitate heat dissipation
Surface
condensation
• Condensation on the exterior surface and door seals of the
refrigerator is normal when the ambient humidity is too high.
Just wipe the condensate with a clean towel.
Abnormal noise
• Buzz: The compressor may produce buzzes during operation,
and the buzzes are loud particularly upon start or stop. This is
normal.
• Creak: Refrigerant flowing inside of the appliance may
produce creak, which is normal.
To Next Page
Loading...
Need help?
General
