MCAC-UTSM-201707 Midea Tropical R410A High Efficient Duct Technical Manual 50Hz
68
1. Notes
WARNING:
Failure to observe a warning may result in death.
Be sure only trained and qualified service personnel to install, repair or service the equipment.
Improper installation, repair and maintenance may result in electric shocks, short-circuit, leaks,
fire or other damage to the equipment.
Install according to this manual strictly. If installation is defective, it will cause water leakage,
electrical shock fire.
When installing the unit in a small room, take measure to against refrigerant from exceeding
allowable safety limits in the event of refrigerant leakage. Contact the place of purchase for more
information. Excessive refrigerant in a closed ambient can lead to oxygen deficiency.
Use the attached accessories parts and specified parts for installation. Otherwise, it will cause
the unit fall, water leakage, electrical shock fire.
Install at a strong and firm location which is able to withstand the set’s weight. If the strength if
not enough or installation is not properly done, the unit will drop to cause injury.
The unit must be installed 2.5 meter above floor.
The unit shall not be installed in the laundry.
Before obtaining access to terminals, all supply circuits must be disconnected.
The unit must be positioned so that the plug is accessible.
The enclosure of the unit shall be market by word, or by symbols, with the direction of the
refrigerant flow.
For electrical work, follow the local national wiring standard, regulation and this manual. An
independent circuit and single outlet must be used. If electrical circuit capacity is not enough or
defect in electrical work, it will cause electrical shock fire.
Use the specified wire, connect it tightly and clamp it so that no external force will be acted on
the terminal. If connection or fixing is not perfect, will cause heat-up or fire at the connection.
Wiring routing must be properly arranged so that control board cover is fixed properly. If control
board cover is not fixed perfectly, it will cause heat-up at connection point of the terminal, fire or
electrical shock.
To Next Page
Loading...
Need help?
General
