MCAC-UTSM-201707 Midea Tropical R410A High Efficient Duct Technical Manual 50Hz
70
Connect the outdoor unit wires, and then connect the indoor unit wires. You are not allowed to
connect the air conditioner with the power source until wiring and piping of the air conditioner is
done.
While following the instructions in this manual, install drain piping in order to ensure proper
drainage and insulate piping in order to prevent condensation. Improper drain piping may result
in water leakage and property damage.
Install the indoor and outdoor units, power supply wiring and connecting wires at least 1 meter
away from televisions or radios in order to prevent image interference or noise. Depending on
the radio waves, a distance of 1 meter may not be sufficient enough to eliminate the noise.
The unit is not intended for use by young children or infirm persons without supervision.
Do not install the air conditioner in the following locations:
There is petrolatum existing.
There is salty air surrounding (Near the coast).
There is caustic gas (the sulfide, for example) existing in the air (Near a hot spring).
The volt vibrates violently (in the factories).
In buses or cabinets.
In kitchen where it is full of oil gas.
There is strong electromagnetic wave existing.
There are inflammable materials or gas.
There is acid or alkaline liquid evaporating.
Other special conditions.
If the air conditioner is installed on a metal part of the building, it must be electrically insulated
according to the relevant standards to electrical appliances.
When all the installation work is finished, please turn on the power only after a thorough check.
Installation order:
Select the location;
Install the indoor unit;
Install the outdoor unit;
To Next Page
Loading...
Need help?
General
