5
INSTALLATION
Install & Fit the Drain Hose
Install the water inlet hose
CAUTION
1.
Fasten one end of the inlet hose to the tap.
Ensure there is a rubber washer inside the
hose before fastening. The washer prevents
water leakage.
Securely tighten the other end of the inlet
hose to the clothes washer inlet valve.
Ensure the rubber washer is inside the hose
before tightening.
When tightening the clamping nut, apply
even pressure. Do not apply too much force
or twist the valve as this may damage or
break the valve joint.
1.
Slide the drain hose completely over the
clothes washer drain outlet.
Fix in place securely to prevent leakage.
2.
3.
2.
PLEASE NOTE
Be sure to install the correct HOT and
COLD water inlet hoses. Incorrect
installation can reduce performance or
damage the clothes washer.
water inlet hose
clamping nut
To Next Page
Loading...
