Why is my Midea MA100W85 Washer not draining properly?
If your Midea Washer is not draining water properly, ensure the water drain hose isn't placed too high or sealed in a pond. Also, check if the internal rubber ring of the drain valve is blocked by dirt. Ensure the water tap is opened.
What does E1 error mean on my Midea Washer?
If your Midea Washer displays the 'E1' alarm, it indicates an issue with water intaking. Check that the water tap is opened.
Why is my Midea MA100W85 Washer spinning abnormally?
If your Midea Washer is experiencing abnormal spin, ensure the door lid is closed and press the 'Start' button. If clothes are piled largely on one side of the barrel or excessively placed, manually balance them. If the washer isn't stable or is inclined, manually balance clothes. Also, check if the motor belt is loosened and balance clothes manually.
Why is no water flowing into my Midea MA100W85?
If your Midea Washer isn't taking in water, check if the water tap is opened. Also, verify if the power is off, the fuse is burned out, the water supply is cut off, or the water pressure is too low. Ensure the inlet hose is properly connected, and the filtering screen of the inlet valve isn't blocked by dirt. Additionally, check if the coil of the inlet valve is damaged or if the 'Start / Pause' button was pressed after the power switch.
What to do if my Midea MA100W85 Washer shows an E3 error?
If your Midea Washer displays the 'E3' alarm, it means the lid wasn't closed before washing or spinning. To resolve this, close the lid and press the 'Start' button.
What does E2 error mean on Midea MA100W85 Washer?
If your Midea Washer displays the 'E2' alarm, it means the water drain hasn't finished. You should check the water level sensor and drain pump.
What does E4 error mean on my Midea MA100W85?
If your Midea Washer displays the 'E4' alarm, it indicates that washing is staying in the barrel. Manually balance the clothes at one side.
What to do if my Midea MA100W85 Washer stops during operation?
If the Midea Washer doesn't start or stops during operation, first try to find a solution to the problem, if not, contact the service centre. Possible causes include a power outage or a burned-out fuse, a low power supply voltage, the water amount reaching the required level, or the washer being set to 'Delay' washing mode.
General safety guidelines and warnings for appliance use.
Instructions and warnings related to product installation.
Precautions to prevent damage to the washing machine.
Guidelines for safe and correct operation of the appliance.
Recommended location and environmental conditions for installing the appliance.
Steps for safely unpacking the washing machine from its packaging.
Instructions for correctly installing the drain hose.
Common problems and their solutions for the washing machine.
To Next Page
General
