Need help?Do you have a question about the Midea MVC-730WV2GN1 and is the answer not in the manual?
General| Cooling Capacity | 2.14 kW |
|---|---|
| Noise level | 55 dB(A) |
| Refrigerant | R290 |
| Power Supply | 220-240V/50Hz |
| Cooling power | 2100 W |
Details on indoor unit codes, capacity ranges, fresh air processing, and heat recovery ventilators.
Factory-recommended combinations of outdoor units for various system capacities.
Step-by-step guide for selecting appropriate VRF system components based on design conditions.
Technical specifications for outdoor units across various HP ranges (8-12HP, 14-20HP, etc.).
Schematic diagrams illustrating refrigerant piping for various HP ranges (8-16HP, 18-22HP, etc.).
Electrical wiring diagrams for 8-16HP and 18-30HP outdoor units.
Cooling capacity tables for 8HP outdoor units under various indoor/outdoor temperature conditions.
Considerations for outdoor unit placement and spacing, and indoor unit placement.
Guidelines for refrigerant piping design, including material specifications.
Safety measures and calculations for preventing and managing refrigerant leaks in the system.
Step-by-step procedures and principles for installing refrigerant piping, including brazing and testing.
Procedures and precautions for brazing copper piping to prevent oxide formation and ensure system integrity.
Purpose and procedure for flushing piping with nitrogen to remove contaminants.
Step-by-step procedure for testing the refrigerant piping system for leaks using pressurized nitrogen.
Purpose and procedure for vacuum drying the system to remove moisture and non-condensable gases.
Procedures for calculating additional refrigerant charge and adding R410A refrigerant to the system.
General considerations for electrical wiring, including power supply, communication wiring, and safety grounding.
Design and installation requirements for communication wiring, including cable type, connection methods, and grounding.
Pre-commissioning checks required before powering on the system.
Procedures for performing trial runs of the system in cooling mode to verify performance.
To Next Page