Solution
Problem
Air conditioner turns on
and off rapidly
Noise when unit is
cooling
Water dripping
INSIDE when
unit is cooling.
Water dripping
OUTSIDE when
unit is cooling.
Air conditioner
cooling, but room
is too warm- NO
ice forming on
cooling coil behind
decorative front.
Thermostat set too warm. Turn thermostat clockwise to a colder setting.
Air directional louvers positioned improperly. Position louvers for better air distribution.
Front of unit is blocked by drapes, blinds, furniture, etc. - restricts air distribution.
Clear blockage in front of unit.
Notes: Do not attempt to repair the unit yourself.
Always consult an authorized service provider.
If the trouble has not been corrected, please contact Concepcion Midea Customer Care
representative. Be sure to inform them of the detailed malfunctions and unit model number.
Clean air filter. Refer to Care and Cleaning section.
Dirty air filter restricts air flow.
Cold air escapes from opened doors, windows, registers. Close doors, windows,
registers.
Extra hot room. Allow additional time to remove “Stored heat” from
walls, ceiling, floor and furniture.
Dirty air filter-air restricted. Clean air filter.
Outside temperature extremely hot. Set to high cool to bring air
past cooling coils more frequently.
Air movement sound. This normal. If too loud, turn selector to
lower FAN setting.
Sound of fan hitting water-moisture removal system. This is normal
when humidity is high. Close doors, windows and registers.
Window vibration- poor installation. Refer to installation instructions
or check with installer.
Improper installation. Tilt air conditioner slightly to the outside to
allow water drainage. Refer to installation instructions - check with
installer.
Unit removing large quantity of moisture from humid room. This is
normal during excessively humid days.
19
NOTE:
-Buttons design is based on typical model and might be slightly different
from the actual one you purchased, the actual shape shall prevail.
-All the functions described are accomplished by the unit, if the unit has
no this feature, there is no corresponding operation happened when
press the relative button on the remote controller.
-When there are wide differences between Remote controller Illustration
and USERS MANUAL on function description, the description on USERS
MANUAL shall prevail.
-The device could comply with the local national regulations. In Canada,
it should comply with CAN ICES-3(B)/NMB-3(B). In USA, this device
complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interfe-
rence, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
-This equipment has been tested and found to comply with the limits for
a ClassBdigital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference inaresidential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not approved by the party responsible for
compliance could void suers authority to operate the equipment.