10
How to Get the Drinking Water
• Push the water shank inward by the cup
• When you put the hand shank inward, there will be some
water outow,when the hand shank is in its original
position,there is no water outow
How to Remove and Clean up the Water Dispenser
Step 1: Remove
• Take out the elements of the water box , stick to both
sides of the water box elements with both of your
hands,and draw out the elements of the water box
outwards through 45 degrees above. You can translate the
water box (to the side of the user) and get the elements
when the elements are out of water valve elements (when
you move the box,be sure that there is no water in it.)
• Take down the seal ring of the water box elements.
• Step to remove the elements of water valve : Use the
screwdriver and make the edge directs to the water
valve elements and then insert it in the free place that
highlights outskirt, rotates the screwdriver clockwise or
anticlockwise,with the screwdriver moving, when it tops
the penstock, extracts the water valve elements by hands
at the direction of above 45°(You can not remove the
elements of water valve)
Step 2: Clean up
• Remove the water box itself, and the water box cover, the
seal ring and the water valve elements.
• Clean up the elements of the water box with cold or warm
water.
• Wipe out the water with dry cloth.
ATTENTION
When you are cleaning the tank and if cleaning solution is used,
you should better put the water box to its original position, and
ll the water box, then you shall drain 5 to 6 cups of water, in
case there is any rudimentaldirt of water dispenser after you used
cleaning solution.
To Next Page
Loading...
Need help?
General
